Skip to content
Black Friday & Cyber Monday Sale! Use code EMRBF24 to save big. Hurry—limited stock available!apply.
Free Standard Shipping for orders over $30 USD (USA and Canada only). Size and weight limits may apply.

FAQ on RF Explorer 6G Combo Plus Slim

Question: 

Does the RF-Explorer 6G combo Plus-slim scan analog and digital signals? 

Answer: 

Yes, the 6G combo plus-slim scans both analog and digital signals. 

 

Question:

What can I do if the device is not booting up properly?

Answer:

You can enter the bootloader mode manually by first powering off the unit and disconnecting the USB.  Then press and hold the LEFT + RIGHT arrow buttons while switching the power on.  This will start up the bootloader mode.

 

Question:

What is the noise floor (typical LNA)?

Answer:

The noise floor is -125 with LNA.

 

Question:

Why does the unit still pick up signals outside of the specified range of the antenna?

Answer:

It is expected that an antenna may detect signals outside of its defined range, however the performance response of these readings are not measured or guaranteed by the antenna manufacturer.  Therefore, the accuracy of measurements in those frequencies is undefined.  For accurate readings across various frequencies, especially in professional settings, calibrated antennas are recommended.  These are typically very large, designed for laboratory use and can cost approx. $2000 USD.

Question:

Why is my battery not charging?

Answer:

You must ensure that the device is connected to a USB power source and switched to the ON position.